My 09 fit Progressive thread. TW/ Stance wheels/ etc.
#1
My 09 fit Progressive thread. TW/ Stance wheels/ etc.
Not much to show but decided to make a progressive thread like others.
How it sits now.
I was planning to run lower, but i scraped(tire+lip) few times today to drive to costa mesa (~20min drive on fwy) So i think the height will stay as is.
Future plan:
-Mugen Rear
-Some sort of front lip
-CF hood
-Double din w/navigation
-Key Light (world1 keylight. Will be going to japan in a month so i'll be purchasing few)
-Roll/Pull fender.
Pictures:
Front View
Shoes.
Falken ziex ze-512. 205/45/16
Red Suede Interior
Matching with Mugen Floor Mat
Trunk Super Bright LED/ Small Sub
License Light LED.
Wide Rear View
Edit 3.16.13
Installed OEM Cup holder light to my fit using SuperBrightLED to go along with it. I had a DIY light already done but this looked very clean so installed it. Took around ~10min (mostly soldering part since space was so limited on that darn plug and if soldered too much, it won't fit in the cover.)
Nice blue light
Soldered.
How it sits now.
I was planning to run lower, but i scraped(tire+lip) few times today to drive to costa mesa (~20min drive on fwy) So i think the height will stay as is.
Future plan:
-Mugen Rear
-Some sort of front lip
-CF hood
-Double din w/navigation
-Key Light (world1 keylight. Will be going to japan in a month so i'll be purchasing few)
-Roll/Pull fender.
Pictures:
Front View
Shoes.
Falken ziex ze-512. 205/45/16
Red Suede Interior
Matching with Mugen Floor Mat
Trunk Super Bright LED/ Small Sub
License Light LED.
Wide Rear View
Edit 3.16.13
Installed OEM Cup holder light to my fit using SuperBrightLED to go along with it. I had a DIY light already done but this looked very clean so installed it. Took around ~10min (mostly soldering part since space was so limited on that darn plug and if soldered too much, it won't fit in the cover.)
Nice blue light
Soldered.
Last edited by kentkanaya; 03-17-2013 at 01:55 AM.
#7
Remove door cover and its straight forward from there. At work so cant really explain in detail.
#9
Installing mugen rear lip soon. And oem led cup holder lights soon.
#12
#15
I wanted to carry back my JDM RS rear bumper but no way in hell i was able to. Its just sitting in my girl's room right now......and her room is not that big hahahah.
Do you know any cheap way of shipping that thing over here to LA?? Hoping i can send less than 300$....
#18
I did it myself and yes the back is done as well just like the front. Its not that hard just very time consuming.
#19
This tail light just so happened to catch my attention at japan so i got it. No regret.
#20
so what's next on your list