Load resistor install help
#1
Load resistor install help
Hey guys!
I'm trying to install some load resistors on my front turn signal switchbacks but ran into a problem. The wires present are black, grey, and green. I'm trying to figure out which of the three are the negative, constant, and pulse.
Also, on my old accord I was able to install the load resistors in the rear tail lights rather than the front. Does anyone know if I can do the same with the fit?
I'm trying to install some load resistors on my front turn signal switchbacks but ran into a problem. The wires present are black, grey, and green. I'm trying to figure out which of the three are the negative, constant, and pulse.
Also, on my old accord I was able to install the load resistors in the rear tail lights rather than the front. Does anyone know if I can do the same with the fit?
Thread
Thread Starter
Forum
Replies
Last Post
SoFit
California - Southern Community
0
06-27-2011 11:22 PM
emmad00d
1st Generation (GD 01-08)
3
01-11-2010 10:04 PM
airborne200208
Fit Engine Modifications, Motor Swaps, ECU Tuning
31
04-23-2009 12:13 AM