picked up a header from Adrian earlier today and had some time to install it, modify the heat shield and mount, wash the Fit, and pre-plan phase two of my airbox mod.

the header was a really nice piece for a Megan replica, welds were ok, no leaks, and made a nice amount of top end power. exhaust is quieter, throatier at WOT, and 3k-5k = ...

 

A new set of Azenis, woot!

*Does anyone have the azenis on their car? Do you hear really loud tire roll/slap or is something wrong with my car? o.O'

 

Specs: A-TECH Final Speed Gear-R w/ Buddy Club P-1 Racing Lug Nuts *Extended* (Not shown are the Volk valve stems, I still need to get it installed)

 

Sexy. Where did you buy the Final Speeds from?

Turn signal mirrors will be installed tomorrow. Need to find my camera so I can post it.

 

oh wow!!! thats pretty sexy...nice wheels, tires and lugs! i got the same lugs. very good quality lug nuts.

 

Well these aren't really new cuz they were sittin in the garage, but I put em on recently:

+Kenstyle rear duckbill
+Mugen trunk garnish (replica)
+Jazz Emblem
+Independent fogs
+Honda Access center console

 

PM me I can special order it for you! :3

 

Thanks, ya these lugs are PURE SEX! I got another set for my next wheels! :3

 

Turn signal mirrors installed yesterday. They are seks. Haven't seen any other GE's with them. Will post pics later today.

 

buying a wide body kit this week

 

 

dude! that looks nice... OEM looking type fitment... get some blinking shots

modded base GEs ftw!!!

 

^^ the wind deflector for the GE looks sweet! like a sophisticated mustache

 

Uhhh...I made my stock tires rub today...hahaha! Don't think I'm gonna try it again though.

 

Hope to have it painted by next week

 

Looking good there Travis!!!!!

 

Green with envy, Trav Lookin good, probably THE best lookin rear lip on the fit. Simple and clean!

 

 

Thanks Peter

You know it!! there are others but this is my favorite

speechless...I love it


It goes to paint tomorrow, and it will be done sometime next week. I'm shooting for Wednesday cause then I can take it to the Grand/Valley meet

 

That is a very secksy look, Trav!

Hahaha... As for me, I'm doing a full bottle Techron cleaning with a full tank of Cheveron gas. I bought a box of 6 bottles for $15 last year and I'm putting it into use now. My RPM doesn't seem to want to leave the 2,500 mark unless I pound on the gas. And torque feels a little better at low RPM.