Valve Cover, Inake Manifold, Throttle Body, EGR valve, etc Torque Specs
#1
Valve Cover, Inake Manifold, Throttle Body, EGR valve, etc Torque Specs
I am looking for the torque specs as I plan on checking and adjusting my valve clearances and cleaning other parts this weekend and I was hoping for some to help me out if someone had the Torque specs information for the following:
1. Valve cover bolts
2. Intake manifold including EGR passage cover bolts
3. EGR valve bolts
4. Throttle body bolts
1. Valve cover bolts
2. Intake manifold including EGR passage cover bolts
3. EGR valve bolts
4. Throttle body bolts
#2
I am looking for the torque specs as I plan on checking and adjusting my valve clearances and cleaning other parts this weekend and I was hoping for some to help me out if someone had the Torque specs information for the following:
1. Valve cover bolts
2. Intake manifold including EGR passage cover bolts
3. EGR valve bolts
4. Throttle body bolts
1. Valve cover bolts
2. Intake manifold including EGR passage cover bolts
3. EGR valve bolts
4. Throttle body bolts
1. 2008 and earlier=106 in-lbs. 2009 and later=84 in-lbs.
2. Intake upper and lower bolts and nuts 17 ft-lbs.
(Support bracket 108 in-lbs.)
3. EGR mounting bolts on 2007/2008 models =17 ft-lbs. 2009 and later 16 ft-lbs.
EGR pipe fasteners 2009 and later = 16 ft-lbs. (Don't know if that is the same as the "passage cover bolts".)
4. Throttle body mounting "fasteners" = 17 ft-lbs.
#3
Note: Below is the terminology used in my Chilton. Don't know if it is actually what you're asking.
1. 2008 and earlier=106 in-lbs. 2009 and later=84 in-lbs.
2. Intake upper and lower bolts and nuts 17 ft-lbs.
(Support bracket 108 in-lbs.)
3. EGR mounting bolts on 2007/2008 models =17 ft-lbs. 2009 and later 16 ft-lbs.
EGR pipe fasteners 2009 and later = 16 ft-lbs. (Don't know if that is the same as the "passage cover bolts".)
4. Throttle body mounting "fasteners" = 17 ft-lbs.
1. 2008 and earlier=106 in-lbs. 2009 and later=84 in-lbs.
2. Intake upper and lower bolts and nuts 17 ft-lbs.
(Support bracket 108 in-lbs.)
3. EGR mounting bolts on 2007/2008 models =17 ft-lbs. 2009 and later 16 ft-lbs.
EGR pipe fasteners 2009 and later = 16 ft-lbs. (Don't know if that is the same as the "passage cover bolts".)
4. Throttle body mounting "fasteners" = 17 ft-lbs.
Thread
Thread Starter
Forum
Replies
Last Post
Letsclique
1st Generation (GD 01-08)
7
05-06-2014 12:36 AM
DrKelso
Fit Engine Modifications, Motor Swaps, ECU Tuning
8
06-22-2009 08:59 AM