I have the 08 Fit (base) and can no longer change the ac/heater vent. The control is just below the radio on the right and only moves about a 1/2" right or left & feels very "spongy". So what I would like to know is, is this the control assembly that is bad or the cable attached to this controller? I would like to get a general idea of what’s going on here before I start ordering parts & tearing into this thing.

Thanks for any help y'all can give,
Brian

 

there are 3 cables that go from the dials to the back of the dash...behind/next to the glove box.

drop teh glove box down and follow teh cables (i think they are purple, orange..adn i foget teh other color). they jsut have a little loop over a pin at teh end...when the dial turns the pin is pulled or pushed to adjust whatever your trying to change. make sure they are connected well.

 

Nighthawksi
Thanks for the info. I'll check that out.