World's first HD plastic reinforcement bar
#1
World's first HD plastic reinforcement bar
I was looking for a lighter replacement to replace the front crossmember with some strength. I thought I saw one for sale for a fit once, but I couldn't find anything but a replacement rear reinforcement from aj-racing.
Using my imagination at work and our new 3 axis router I found some utlra high density plastic and cut one to the length of the front crossmember. Don't ask me about performance difference but I am looking at a jdm body kit and I wanted something thin to replace the support I took off. This piece is very ridgid and light, I thought I might make one for the rear too. I love free mods!
Using my imagination at work and our new 3 axis router I found some utlra high density plastic and cut one to the length of the front crossmember. Don't ask me about performance difference but I am looking at a jdm body kit and I wanted something thin to replace the support I took off. This piece is very ridgid and light, I thought I might make one for the rear too. I love free mods!
Last edited by jits14; 09-09-2008 at 11:20 PM.
#5
sex.. that is all
Thread
Thread Starter
Forum
Replies
Last Post
gd3kamiwanaB
Fit Photos & Videos
40
03-09-2012 09:29 AM
abscooter
Fit Suspension & Brake Modifications
14
06-26-2009 10:16 PM
bar, bars, engine, fit, hd, honda, motor, net, pastic, plastic, rear, reinforcement, reinforcing, reinforment, reinforsement