So i got a T1R V2 muffler and i also have the Progress RSB. I've notice when i drive the exhaust hits the bar and a part of the exhaust hits it. I want to know if anyone else has this set up and possibly have the same issue or is it just me.

 

I'm running the same setup, but I never had that issue before, beside that the can isn't flatblack, but I fixed that already

 

I have the same setup but do not have this issue.

Did you lower the car though?

 

same setup here also and no rubbing.

 

try this vic. you know the rubber things on the hangers? well there is like a hole in the middle try hanging the exhaust from that

 

There should be a lot of clearance from the axle pipe to the RSB unless your car is super low then that could possibly be an issue.

I will suggest you to try wait4thefit's idea and that should work.

 

clank clank rattle rattle clank clank.

 

fixed the problem no more issues!!!!!!! Sounds good and maybe its because i havent heard my car with an axle back for a few months but this V2 muffler sounds louder than my old VIP.

 

+rep for this...

thanks, i didn't think of this. it raised my t1r 50s V1 closer to the car 1". i'm so much happier with it now.