I put in an Tanabe Medalion Touring exhaust today. I took about 20-30 minutes including cleanup.
I just took it around the block to check it out. It is still pretty quiet, but a nice deep tone, and not any seat of the pants HP, but then again I didn't expect any from an axle back.
Its a real nice piece, there are gussetts at both ends of the muffler to the pipe and its got a pretty nice polish on everything. Too bad I'll probably only keep the tip looking good.
Before


After


Not the most flattering image, the exhaust doesn't hang down or stick out as far as it looks in this pic. I'll try to get a better pic later.

Comparison

 

Okay here is a better angle. Well except for the reflection of me in it. But it gives a better idea on the fit of the exhaust. After a few days of driving I do notice it got just a bit louder but still pretty quite though.

 

nice lookin pics.. but the price tag is still to high IMO

 

wow looking good man

 

Awesome! Hope you enjoy it!

 

Man, at first I thought you were illustrating a scratch on the car. I was like.. OUCH.

 

if you guys hang around a bit, for the price of an axle-back, i'll be able to provide a full catback for around the same cost!!!

 

Any chance at getting a sound clip of the Tanabe

 

Someone else had a clip on here somewhere of it. I don't have a way to up load anything though.

 

nice exhaust! always liked Tanabe exhaust.....good quality

 

All mods for the Fit are easy. Just remove some bolts, put them back.
Im putting my header in today. Should be a 20min job.