has anyone replace the factory rear spoiler that over the hatchback part (guess that is called the roof spoiler?) ..what did u replace it with and did u have to drill holes in the new one or does it screw in from under neath ?
what all did you have to do to install?

 

I got the VTi-S Spoiler. No new holes, two screws attached to the spoiler that go into the outer two existing holes.

 

where did you get it and what was bout the cost of it....
how did you install it was it screws that screwed up from underside of hatch? doesnt the factory spoiler bolt from roof down?

 

however if you put on spoon or mugen spoiler you will HAVE to drill into the hatch.

 

that is what i am trying to avoid (dont wantto drill) and find a direct replacement that is little different in style or bigger

 

looks like your best bet is that VTi spoiler.

 

where can i get one to fit a us 07 fit sport

 

do they come prepainted?

i'd deff be interested in a TW one

 

hit up ben or dickson at aj-racing.com

 

Hit up Ben at AJ, he is the Fit specialist!

 

What about the Fab spoiler? Would that be a direct replacement, or would new holes need to be drilled?

 

im sure the fab spoiler also needs drilling

 

Ben from A&J can get you one as that's where Illusive got his from.

 

how much do they cost?

 

I don't know. Check with Ben or Illusive.

 

Ehhhh I'd ask Ben. I got the first and only one he brought in, so if he is bringing more of them in, then it should be cheaper. Attachment is through 2 screws. One on either end is affixed to the spoiler. Two existing nuts need to be re-used from the stock spoiler in the same locations.

 

Did yours come pre-painted VBP?

Does the entenna get in the way when you open the rear?

No problems with the rear windshield washer arm?