I just found the wheels I'm going with on my fit, but running flares would make it so much easier. VIP status
So my question is, has anyone been able to find any for the fit yet? I have yet to find any. I'll custom make them, or get them custom made if I have to, but I was hoping to find some already made

 

I wish some one made these, this is an Sport Extreme Concept car.

 

These are the sex...available in carbon fiber and fiberglass. You'd probably need to be JDM front/rear to work.





Not sure if you need their kit though either to make them work.

Check out Corrmann

 

theyre not bad... a little too bubly for me... i think something that followed the oem lines more would be badass.

 

agreeedd a little too much imo

 

Didn't Skunk2 flare out the fenders on their Fit?

 

Ya they flared out the front. it looks clean. but i think they did it custom themselves.

 

I def think a clean pull would look better than those bubbly overs...I haven't seen any other over fenders offered though anyone.

If you really wanted to get creative you could get some of that planters foam, model your own, and then lay glass.

 

the ones on the j's k24 fit are dope, Id love to have some

 

I dont really like the glass ones. what happened to good old metal working???

 

That's the route I'd like to go. Either way, I need something. 16x9's with a +5 and +15 offset are going to need some work...

 

Yes they will

 

Camber and flares

 

and probably body work. thats the same set up as the phase 2 integra but honestly i think x8.5 is about as wide as you can go with squeezing in the back with rolled and pulled fenders. i think the fender flares will look corny

 

 

Gotta love the phase 2 cars. One way or another I'll make it fit. I was gonna throw the 16x7 rega's on it, but I really just wanna cram a fat ass lip on her. There is another fit with flares that is running a 16x9. I'd really like to know who did his body work. They did a good ass job.

 

I love Mikey and Arnel's cars. Dope guys to chill with too!!

 

i think fender flares are ugly, unless they are custom done and don't look like you stuck them on with double sided tape

i like the skunk2's fit's fenders
looks good, but not too much

 

i found one of a japanese fit with 10's in the rear but he had to have body work done but before that he had 9's but i dont know the offset and i lost the website


16x8 +15


16x9 offset?????



x10

 

Hope you can get a deal on tires because that neg. camber is going to eat through tires