Hello i have a 2004 honda jazz uk my dad gave me his mk1 crv with a b20 and im going to swap the crv engine and drive train into the jazz will be modifying the driveshafts and propshaft to fit was wondering is the front hub flange as its splined would fit the rear hub is it the same depth were the bearing is pressed onto and if its the same diameter or would i have to get a wheel bearing made up cheers ben

 

Where is the prop shaft going to go?

 

I going to cut and box a trans tunnel if the 1 thats there isn't deep enough to run the prop pretty easy as the jap models they had a awd model just using the measurements from that