So, what do YOU have on your display on your scangauge?

Has anyone tried to see how accurate the horsepower reading is?

I think I'll be doing:

MPG Coolant Temp
GPH HP

 

CWT, CIA, RPM, and TPS are the ones I use most often. the hp x-gauge reading.. i don't know but I find it way off.. Like one time it reads 140 and I was like wtf

 

I just got my Scangauge 2 - installation was easy and use is pretty easy too. I'm trying to figure out where to mount it. So far I'm trying the side and the center. Anyone have any suggestions for the best place?

Using it, I'm learning so much about this car. I did a brief interview with someone at Linear Logic and I'm looking forward to writing it up for my next column on AutoChannel.com (A More Perfect Fit). Meantime, here's a couple of photos:





This is truly a cool piece of tech!

 

i have RPM, GPH, MPG, and coolant temp up....

 

I have volts, mpg, intake temp, coolant temp,

and here is where I mounted mine

 

I would highly highly recommend putting it on top of the center of the steering column.

It covers my TMPS light and is completely convenient. It's as easy to look at as my speedometer and the cord is easily tucked down and to the right or even inside the steering column routed down through the dash.

 

i concur with the steering wheel column mount... i had it on my dash and i looked like crap... moved it to the column and love it, easy to see, non obstructive... (except the idiot lights) and looks clean!

 

 

AFE (Trip MPG), MPG, MTE (miles until empty), 4th one rotates..MPH, RPM, FWT, etc.

 

Hey, how did you mount yours there? Would I be able to do the same but mount it above the mirror?

 

I'm showing MPG, TFE (tank fuel economy), CFE (current fuel economy), TPS or MPH

 

I do Instant MPG, Trip MPG, Intake Air Temp, Water Temp. Sometimes put LOD in place of IAT.