gloss black vinyl for roof
#41
update: did the top part of the windshield, when i put it on, it looks fine, but once it started drying, bubbles started popping up. I hope these go away. anyone has a detailed DIY of how u should put on the vinyl.
#43
Did you squeegee out the air bubbles first?
Let it sit in the sun for a day or two and most of the time it just disappears. However, any dust or particles that got in between can not be fixed.
give me a call if u need help.
Let it sit in the sun for a day or two and most of the time it just disappears. However, any dust or particles that got in between can not be fixed.
give me a call if u need help.
#44
i didn't squeegee out ALL the water, but when i applied it i squeegeed out what i can see that were bubbles, and it was pretty good looking at that time (at least it was flat but wet). But after it dried in the sun for a few hours, now its got all these ugly ass bubbles that look like acne on the strip. its very annoying and i don't think they'll go away.
#47
I doubt anyone can tell you in this thread but I would try the SoCal thread though since they might know.
Thread
Thread Starter
Forum
Replies
Last Post
Vash
2nd Generation GE8 Specific Fit Photos & Videos Sub-Forum
7
08-31-2010 01:06 AM