My Fit Total Part-Out Sale!!
redrumm I'll be sending yours out today. Yesterday was a bad emotional day for me and I didn't even go outside at all. I'm getting to you don't worry, I'm not like iKona. I'm legit.
Everyone who bought from me, your items have been shipped out and should arrive early next week!
Still have:
Mugen shifter
JDM console
Weapon R trunk cage
J's c-pillar
J's front lower arm bar
Benen tow hooks
Skunk2 knob
Still have:
Mugen shifter
JDM console
Weapon R trunk cage
J's c-pillar
J's front lower arm bar
Benen tow hooks
Skunk2 knob
you should sell the trans, ecu's, and cluster with all harnesses to someone that might wanns convert to M/T
start a new post i bet you could make quite a few bucks, hell if i remember right you have a bit of time on your hands right now and if it were me that fit would look like this
well your will be black, usdm, and have frontal damage! BUT YOU get the idea - right?
dude even your side airbags are valuable
shit man PIECE THAT S H I T OUT
start a new post i bet you could make quite a few bucks, hell if i remember right you have a bit of time on your hands right now and if it were me that fit would look like this
well your will be black, usdm, and have frontal damage! BUT YOU get the idea - right?
dude even your side airbags are valuable
shit man PIECE THAT S H I T OUT
Good-luck with your sales man, I admired your fit - shame to see it go.
But when you removed the visors, how'd you go about doing it? Did you just pull them off and there was no residue from the tape?
I ****ed up on my passenger side Mugen Visors when I installed them, so I was thinking about replacing them. But the double-stick tape is practically melted on there (Thank you 40+ days of 100F+ weather, Texas..).
Any tips on clean removal?
But when you removed the visors, how'd you go about doing it? Did you just pull them off and there was no residue from the tape?
I ****ed up on my passenger side Mugen Visors when I installed them, so I was thinking about replacing them. But the double-stick tape is practically melted on there (Thank you 40+ days of 100F+ weather, Texas..).
Any tips on clean removal?
I took off and reapplied my Mugen visors back in the day in Florida. It was over 90 degrees when I did it so I just gently started from the back corner and peeled it off. For the residue I got as much as I could with my fingers and then sprayed Goo-gone on a rag and scrubbed the rest off.
bump for lower prices. Full trunk cage 4 pc. set is now $280 shipped. J's C-pillar is $150 shipped, JDM console is $220 shipped, Mugen shifter is $190 shipped, Progress rear sway with stainless flatbolts is now $130 shipped!!!!!!!
