Thread: Hardwire Valentine One in Fit
View Single Post
  #2 (permalink)  
Old 04-17-2007, 01:51 PM
spreadhead spreadhead is offline
Member
iTrader: (0)
  
Join Date: Jun 2006
Location: Chattanooga
Posts: 563
Rep Power: 1718231
spreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to livespreadhead relies on Rep Points to live
I have a V1 hardwired in my Fit, although it is by my mirror not on the dash as you want. I used a Scotchlock RadioShack.com - Cables, Parts & Connectors: Connectors & connectivity: Crimp connectors & terminals: Wire Tap-In Squeeze Connectors (10-Pack) to tap into the cigarette lighter for power and put the Direct-Wire Power Adapter inside the under dash panel on the passenger side. I used these RadioShack.com - Cables, Parts & Connectors: Wire & cable management: Wire clips & holders: Telephone Adhesive-Backed Clips (9-Pack) to run the wire up the side of the dash, I then tucked the wire under the passenger side windshield pillar trim (using caution as this is also an air bag) and headliner to the mirror mount. I also have a Concealed display mounted in the "cubby hole" by the small window on the drivers side. I used the same clips to run the wire up the side of the dash for this too. I used one of these The Radar Mount for the Escort or Beltronics to mount the V1 to the mirror as I have an aftermarket mirror, this mount WILL NOT work with the factory mirror.
Last edited by spreadhead; 04-17-2007 at 02:10 PM.
Reply With Quote