When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I tried to install an XROSS aftermarket Chinese Android stereo in my 2010 Fit Sport non/Navi and blew some fuses .
Turns Out they sent the wrong wiring harness. So I stuck it in the back of my car and roll around with it like a dead squirrel.
back a year later, now December 2018, I purchased a 10.1 inch Chinese android eight that one aftermarket stereo pre-installed in a 2010 Honda fit trim plate.
I tested the radio fuse and the fuses under the orange puller in the fuse box and replaced those that were blown.
After plugging it all in, Nothing. So I tested power at the wiring harness and found constant power available on the yellow wire but no power available at the accessory wire (red)
Plugging the radio directly in to a 12v power supply fires up the device just fine. But so far, not from my wiring harness.
Which fuse controls the accessory switch enabled at the ignition switch?
