Fourunnerguy's 2013 GE8 Sport
#41
Your nuts look great!
Would you mind posting more detail on the rear wiper delete? I was thinking to set one up using a threaded nut glued to a piece of plastic, then using a bolt from the inside.
Would you mind posting more detail on the rear wiper delete? I was thinking to set one up using a threaded nut glued to a piece of plastic, then using a bolt from the inside.
#42
Hey thanks! I actually just pulled the plastic from inside the hatch and unbolted the whole motor, didn't take more than a half hour to do all of this. There's a rubber grommet I had to pull through or else it will stick out of the hole. I then used a 3/4" plug with a small amount of electrical tape to close up the hole. If any water gets in, it wont come inside the car.
#47
Ok, time for some more updates! First, I started by paint matching my mirrors!
Then I installed a Progress sway bar I picked up off Craigslist. Haven't had much of a chance to test it out yet.
I also ended up cutting the fake diffuser out of the rear bumper! I like how much more aggressive it is! I plan on painting the ends of the rear frame rails flat black when I have time and the weather cooperates.
Still waiting for more parts to come in; one of them being an intake from Japan!
Then I installed a Progress sway bar I picked up off Craigslist. Haven't had much of a chance to test it out yet.
I also ended up cutting the fake diffuser out of the rear bumper! I like how much more aggressive it is! I plan on painting the ends of the rear frame rails flat black when I have time and the weather cooperates.
Still waiting for more parts to come in; one of them being an intake from Japan!
Last edited by Fourunnerguy; 05-25-2020 at 08:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Alco RS-1
2nd Generation GE8 Specific Fit Photos & Videos Sub-Forum
0
07-09-2016 08:08 PM
intothesound
2nd Generation (GE 08-13)
9
09-30-2013 04:24 AM
Sapper
2nd Generation (GE 08-13)
28
01-05-2013 10:32 AM