FS: Custom SRI Intake and Heatshield
#1
01-17-2011, 01:43 PM
FS: Custom SRI Intake and Heatshield
Ok folks, I am selling my Custom made intake with the Heat Shield I hand fabricated along with it. This is for a GE8. I decided to go back to stock for now and I want someone else to enjoy this intake.
Due to the position and the Heat Shield I was able to get 4.9HP out of this awesome setup.
DISCLAIMER - This will give you a CEL unless you make an insert for the MAFS tube I am using to make the inner diameter 2" instead of the 2.125" i have it set up with now.
I am looking to get 150 Shipped within the continental US. I will go cheaper if you want to pick up and I can help you install if you want.
If you have any questions please let me know. There are a couple of parts reused from the stock intake so please ask me about this if you have any questions.
Here are a couple photos of the Intake and Heat Shield.
Due to the position and the Heat Shield I was able to get 4.9HP out of this awesome setup.
DISCLAIMER - This will give you a CEL unless you make an insert for the MAFS tube I am using to make the inner diameter 2" instead of the 2.125" i have it set up with now.
I am looking to get 150 Shipped within the continental US. I will go cheaper if you want to pick up and I can help you install if you want.
If you have any questions please let me know. There are a couple of parts reused from the stock intake so please ask me about this if you have any questions.
Here are a couple photos of the Intake and Heat Shield.
Thread
Thread Starter
Forum
Replies
Last Post
integradriv3r
Fit Engine Modifications, Motor Swaps, ECU Tuning
29
03-14-2016 04:10 PM
Pepperinyoureye
Fit Engine Modifications, Motor Swaps, ECU Tuning
203
11-04-2008 11:08 PM
OneStopCustoms
Fit Engine Modifications, Motor Swaps, ECU Tuning
20
12-16-2007 07:32 PM
