Floppy cup holder
#1
Floppy cup holder
So I pulled the cupholder next to the driver's door on my 2018, a little too far out. Heard what sounded like some springs popping....and now it's all floppy. Anyone have a solution for this (I'm hoping it's not taking the dash apart)
#4
well it was my fault. I was intentionally pulling on it...trying to get the top arms to come out, so I could run some wires thru it. So, it wasn't a flaw...I just didn't know there were springs holding it in place...
#5
did you have to take the whole dash apart? Or can you take just the cupholder section off on it's own?
#6
At this point I think there is a screw or two (maybe more) before you can pull out #3.
It was awhile ago that I did this.
#7
Take out your wires so there's no evidence you were messing with anything, then let the dealer replace or reassemble it under warranty?
#9
#11
YAC YC-H4 compatible with 2010 Honda Fit Sport
is this compatible with a 2010 Honda Fit? The cupholder in the 2009-2013 doesn't have a hinge, so wondering if this will work with the non-hinge driver side cupholder.
#13
I'll bring back to life this thread since I had to remove it because I accidentally spilled a soda and wanted to clean it.....
Yo do not have to remove the dash... The floppy part can be removed by itself...
The part circled in red has to be pushed down firmly while pulling it out to free it from the hole in the dash and after that you just pull the part up and it will pop out without any problem....
Yo do not have to remove the dash... The floppy part can be removed by itself...
The part circled in red has to be pushed down firmly while pulling it out to free it from the hole in the dash and after that you just pull the part up and it will pop out without any problem....
Thread
Thread Starter
Forum
Replies
Last Post
simonx314
3rd Gen GK Specific Fit Interior Modifications Sub-Forum
59
11-16-2023 08:36 AM