I already saw the angel eye kit forum...but no one really did an install yet...here is the kit i have...i know how to take apart the lights and the whole heating in the oven process, and the removal of the bumper and everything...but the wiring is a b%^#...im not sure how to do them, cuz the instructions dont even go into detail...theyre ccfl angel eyes, and yes they do fit the usdm headlights, but the makers wont help me on the wiring process...any help is much appreciated, thanks

here are some pics

 

I am dead curious how this goes....
help this fella out!!!

 

Well, in case you don't get any explicit feedback in a timely manner; here goes.
I just recently started thinking these may look good on a Fit, but I haven't yet justified their purchase.
As I understand it they basically look like a "halo" around the headlight, right? Well, if it were me, I would primarily want them to be "on" with the parking lights for their own visibility, and then also "on" with the headlights for that "halo" effect.
If so, all you have to do is wire it directly to the parking lights up on the top of the headlight assembly. You can use those little blue connectors that you squeeze the little aluminum center piece down onto your "halo" wire and the parking light wire. (I would move back a couple of inches from the parking light connector; ideally.)

I hope that helps.

 

wire them via the parklights' wiring.you just have to splice them to the wires. not sure what color the wires are but negative usually has a black line.hth

 

diito it should be easy, - splice the wires- use taps, or just cut and re-tape .
take some pics

 

According to this Fit Service Manual Diagram, Wiring Diagram ,
there is the grd. which is black, and the hot wire is blk/red.

 

can anyone post step-by-step instructions on how to do this? package came with no instructions, just the parts -_______-