J's Racing just released their new header which will fit onto the USDM Fit. Stainless steel made with 28mm piping, 4-1 designed. J's Racing claims the header made 8hp (to the crank).

Available - End of Febuary





I have seen this prototype in person and it is very light and the welds are nice. Can wait wait to see the actual product

 

nice has an o2 bung. any idea on how much louder it is vs. stock? also approximate cost?

 

yes approximate cost would be good I am broke but I am addicted to modding my Fit! If it costs over 5 bills though (which is highly likely) I might have to save up for JR supercharger. It may cost a lot but will get you a lot of bang!!! N/A on L-series can only make so much power

 

Ben, I'm assuming this is the exact same header they've posted on their site, right? If so, are you going to be getting any of the thermal-wrapped versions?