eh i got bored

 

think we might have the same cai? what 1 is that

 

not bad, and if you take a polisher to it, I bet you can make it almost flat almost a single piece looking.

So the point of doing this was to potentially go turbo/SC? for NA is there any improvement in airflow? time to make a nice turbo mani/header now...=)

 

nice, very nice! did you build the plenum yourself? if you did mad props to you.nice welds btw
i knew someone was going to this sooner or later. the design of how it was attached was just begging for someone to make a different plenum or ITBs.
while looking under the hood of my car the first week i had it. i told my friend that "one day, i'll just be bored enough to build some ITB's for this thing" he said "if you don't someone will do it soon enough, it looks too easy"

 

well i hit the dyno before and after i made 97.6hp with just an intake i made 2 more hp after 6k haha so it was worth nothing im gonna redesign it prolly with longer runners cause i lost 3 hp threw small mid section. just a larger plenum it does drive noticeably smoother and there is less of that dbw lag. as far as turbo yeah prolly soon. i did make the plenum myself i do this stuff for a living and turbo manifold will prolly be next i do want to make more then 105hp with bolt ons so one thing at a time

 

oh yea scope this haha now thats how you use a fit

 

ya i get bored and weld manifolds all the time

 

WOW - very good welds! Very creative.

If you get REALLY bored you could test the flow/pressure difference. You could probably make some good cash making more of these, too!

 

nah im not one to get into the honda market ill stick with bmw porche audi 666 Fabrication - Quality that lasts an eternity but if i do happen to make good power after the the remake and make over 105hp then ill prolly end up selling it all and going to stock

 

After looking at your site, the manifold you made for the Fit looks like a modified M42 short runner...


Am I right? Do I get a cookie?

 

no it was a left over plenum and we tried to sell it and it did not sell so i made this for my fit we use the same materinals to make all plenums

 

didn't you have this plenum for sale on honda-tech a while back? now that i think about it that plenum is way huge for the L15.
if you make a turbo manifold, i want in.

 

well yes it was for sale on honda tech and no it "fit"s just fine for the L15 i just have to buy cast aluminum elbow to redesign and maybe some sort of fuel management to change Mr VTEC and stuff then its onto exhaust work to get that 105hp i really really want haha