Worth the money to get a header and B-pipe?
Worth the money to get a header and B-pipe?
I currently have an Aspec axle back and am thinking about getting the mid section and also a header. Is it even worth the money to get a header and finish my exhaust? Will I get or feel any hp gains from that? I am going to be running an intake as well and no tuning. Thanks.
The header and intake will give you noticeable power gains, but I'd only go with the b-pipe also if you decide you want to go FI. Keeping the Factory B-pipe will also keep your exhaust from getting tooo loud.
Ok cool, so don't waste my money on a b-pipe then. I do not plan on going FI. I am just adding a couple of bolt ons. I will be going with a short ram intake and I already have an Aspec axle back exhaust. So I should be good with just adding a header and I will get gains from it? Thanks.
i donno. ive modded many NA's in the past and the performance gains are only marginal... (you gain noise).
if i were you, i would invest more money on the suspension and wheels/tires.
if i were you, i would invest more money on the suspension and wheels/tires.
A Header like a DC Sports or T1R will give you more midrange for sure because of the sightly bigger pipes and '' A LOT'' better collector!! A race Header like the Weapon R Race will give more top end power!!
If you have an AT go DC or T1R... MTX, it depends of your goals!!
As of the B-Pipe, like the others allready said, it's unlikely to give big gains on a Fit with only a couple of bolt-ons!!
If i were you, i would put an a Air Intake (Fujita, AEM, Injen!), then a Header and then a Pulley... Polishing the lower plenum maybe will net you some power and it's almost free if you have a dremel and some skills!!
Marko!!
If you have an AT go DC or T1R... MTX, it depends of your goals!!
As of the B-Pipe, like the others allready said, it's unlikely to give big gains on a Fit with only a couple of bolt-ons!!
If i were you, i would put an a Air Intake (Fujita, AEM, Injen!), then a Header and then a Pulley... Polishing the lower plenum maybe will net you some power and it's almost free if you have a dremel and some skills!!
Marko!!
~Robert
Thread
Thread Starter
Forum
Replies
Last Post
BigTuna_GD3
Fit Engine Modifications, Motor Swaps, ECU Tuning
11
Nov 26, 2010 11:43 PM
setter11
Fit Engine Modifications, Motor Swaps, ECU Tuning
10
May 4, 2009 01:43 PM
drzenitram
Fit Engine Modifications, Motor Swaps, ECU Tuning
1
Jul 7, 2008 01:32 PM
explosivpotato
Fit Engine Modifications, Motor Swaps, ECU Tuning
1
Jul 3, 2007 08:35 PM
TomiGunz
Fit Engine Modifications, Motor Swaps, ECU Tuning
12
Feb 1, 2007 10:00 PM





