Just go the H-Fit Type M Axle Back

Ready to install, I have already installed the A spec but that was when the car was brand new, i now have 34K miles.

the bolts have some surface rust now.

question is H-Fit did not send any hardware, they stated in the email I should use my stock hardware.

since the bolts have some surface rust, would honda just carry the bolts? and should I pick them up and should I pick up a new gasket and bushing?

thanks in advance guys

 

Don't think surface rust will make much of a difference - if you really want new ones, part #18231-SR3-A22 for just the bolts (no springs).

You might want a new gasket but I haven't had any problems reusing my stock one 3 times now.

Nice choice with the muffler, I know I love mine.

 

I think you should be fine, but just to be on the safe side install the new axleback and test for a leak around the seal. Post up a review of the H-Fit exhaust when you get the chance, with some pics at various angles. I am serious considering this exhaust, but H-Fit hasn't really done much for informing us on performance. Still waiting on that dyno they promised. I really like the stock/sleeper look of it though. I don't really like our stock dolphin tip exhaust, but I guess it's better than a pea shooter.

 

ok guys thanks a lot!!

i will post up a review and i will take pics of the install and such, if i can figure out how to do a vid clip i will do that also!

check back wendsday or thursday

 

where's the pics and vids!?

 

Ya bud just put it on with the bolts. If they cause problems later down the line please feel free to just get a new set but if there holding up with ur aspec then they will hold up fine with the new axelback. Wheres the pucs and videos dude?