Thinking of going with DIY Axleback...
#1
Thinking of going with DIY Axleback...
So, me being a cheapo and not wanting to pay 400 bucks or 300, I'm looking into making my own axle-back exhaust, simply by buying the brackets to weld the pipe onto, bend the pipe, and get a cheap glasspack and tip. Is there anyone here that's done this and has any advice? Or an estimate of what it would be to have a shop do the same thing? My issue is, I don't want to hack up my OE exhaust, just in case I take it to the dealer I bought it from, because I have a feeling they'll get P.O.'ed and tell me my warranty is denied. So, I'd like to have a completely new exhaust so I can interchange between the two. But I would like something with a deep sound. Nothing raspy. I like feeling the growl. I was kind of looking at a glass pack for this, or a Weapon R Cannon. From what I've read, they seem pretty good, and are only about $66.
Thread
Thread Starter
Forum
Replies
Last Post
xonexlifex
Fit Engine Modifications, Motor Swaps, ECU Tuning
38
10-04-2014 09:18 PM
Rhino1790
2nd Gen GE8 Specific Fit Engine Modifications, Motor Swaps, ECU Tuning Sub-Forum
3
02-04-2011 06:59 PM
umop-apisdn
2nd Generation (GE 08-13)
4
07-24-2009 01:32 PM