Man.. I tell ya.. That was a pain in the arse to put on. It took me and a friend about an hour to put it on. Had to extend the backup light on the driver side as usual, but the passenger side I had to extend the BRAKE light wire. Not the turn signal.. I had just enough to wedge in the turn signal. Boy did it take some work.. I'll get pics later..

 

tell me about it!!! but they look clean when done!

 

I had to extend the turn signal and break light on the passenger side. 5 wires in all. On the drivers side I just had to extend the reverse wires.

 

Bennet,, the passenger side,, if you pop the rear panel out, you could've popped off the clip that's holding down the wiring harness and get that extra length. hehe..

 

did that still no workie.

 

i had to pop off two clips for the passanger side

 

i had the same problem with bennet. i took off the entire rear panel looking for ANY slack and didn't find one inch. I had to extend 5 wires on passenger side and 2 wires on drivers side. It's cool tho, i'm good with soldering it didn't take me long.

 

I am looking forward to having these problems sometime next month

 

I wanna find the full clear maybe.. they are hard to find though and expensive as crack

 

was there any fitment problem with lining up to the bumper and looking like factory?

 

looks fine. although mine had different sockets for the lightbulbs so I had to force them suckers in

 

yup same here, but they stay jus fine when pushed in? haha