my buddy installed it and a lot of the time was sanding down the reflectors so the paint adheres.

a real hid has such a good cutoff, the load wouldn't matter unless it was pointed to high in the 1st place.

 

How much did it cost you in the end?

 

HID rulz...........

 

Go to their website, you can see an interior picture of the aiming switch. Wonder if the motors adjust the reflectors and the HID's are attached to them, we could have aiming HID's. One thing since most of the load space is between the wheels how does loading affect headlight aiming? Looks like I need to invite some friends over. Will be going to the UK next month and expect to bring back a couple of the manual aiming switches.

 

Your retro looks pretty good, but it seems that you're getting quite a bit of light leaking from behind the bezels. Are these the e46 ECE single xenon projectors? Is there a lot of room in the housings when you crack 'em open?

Has anyone tried a Bi-Xenon retrofit yet. I'm thinking that a set of TL projectors with a custom fiberglass bezel would look good.

 

Just got mine retrofitted and they're goin on tomorrow afternoon!!!

 

Post some pics. I'd love to see what they look like. What projectors and bezels did you use?

 

I'll make a new thread, cause I don't wanna tread jack Robert. The install has been set back to tonight cause some other things came up that I have to take care of asap.

Mine look VERY similar except where the running light on the top, instead of smoked out like Roberts, mine are Amber-ed out. I used TSX projectors and MDX shrouds.