All rear lights went out!!
#1
All rear lights went out!!
I replaced my rear license plate bulbs with LED 194's tonight. Everything was fine for about 10 minutes then all my rear bulbs went out (license plate lights and all other rear bulbs!). I tried fuse numbers 1 and 5 (10A) but they are fine. One of the 30A fuses looks a little off, but does anyone know for sure if there is one fuse that controls all these? The owners manual explains every other fuse except for the rear bulbs.
The brake lights still light up if you hit the brakes though, and everything else I checked still works (horn, locks, reverse lights, all interior lights etc.). If I don't figure out which fuse it is by tomorrow, it will have to go to the dealer! Help!!
Here are the 194's I used:
194 Size Car LED Bulb
The brake lights still light up if you hit the brakes though, and everything else I checked still works (horn, locks, reverse lights, all interior lights etc.). If I don't figure out which fuse it is by tomorrow, it will have to go to the dealer! Help!!
Here are the 194's I used:
194 Size Car LED Bulb
Last edited by reako; 12-21-2008 at 10:19 AM.
#5
Thanks! I have since swapped out the LED's I had installed to the OEM halogen bulbs. Once I figure out the right fuse # and replace it, I guess I will just send the LED's back to the manufacturer (Oznium.com) and try Superbrightleds.com in stead (based in STL).
#7
Fuse #29 was it!!! Thank you!!!! FYI the manual states #29 is "Small light", this fuse controls the front and rear driving lights, and HONDAMATIC just saved me a trip to the dealer, thanks again for responding so quick!!
#9
lol..
ok so reako, since replacing the fuse in #29, all is still ok?
my leds are in the mail as we speak, so i need to be prepared in case all hell breaks loose.
ok so reako, since replacing the fuse in #29, all is still ok?
my leds are in the mail as we speak, so i need to be prepared in case all hell breaks loose.
#14
I'm interested in replacing rear parking, brake, and license lights, along with front parking lights (amber) with LEDs. Which ones did you guys use or recommend? Also how is the brightness compared to OEM filament bulbs? Any pictures?
Thread
Thread Starter
Forum
Replies
Last Post
Tranas
Fit Interior & Exterior Illumination
1
06-21-2009 05:23 PM