Hello, after being so good for so long, the rear pull-out cup holders were slid out and I was not aware of it as I put the larger seat back done to the floor and broke it right off! Actually it just took the front of it off, but still. I should have seen it earlier than I did, but when I did it was too late. I glued it back on with super glue, but that only lasted a month. Does anyone know 1) how to get the rest of the assembly out, with out removing the whole thing, and 2) where I could possibly get replacement parts for it? I also need the the latch for the armrest, as that has been broken for a while but now that I am looking for parts should try to get on of those too.

 

please help

 

Hey, Vinnie, sorry to hear about your armrest problems. As manxman, I helped to push the group buy for these to its conclusion and get them all shipped (and wrote a lot of the Progress RSB posts). I installed my center armrest in my GD3, and my Fit was totaled about 8 hours later in Sept. of '08. I don't remember enough about the design or installation to offer any help to you now- sorry. It's nice to see you again, but not for these conditions. If I were in your situation, I would completely remove the whole assembly and figure out repairs out of the car. Good luck!