THE FORMER photo post
#541
Hey man...I am in the same boat too. I got some rims 16x7 with +40 offset that already had 215/45-16 tires mounted on two of them. I test mounted it and it only rubbed on the widest turn with hard acceleration. I am not on T1R springs though, but on Eibach Pro-Kits so the drop is less. I rolled the fenders in the front anyways and I'll get some real review after driving on them tomorrow.
#543
dacalac, dou have any new range of wheels for sale?
#544
I already have the camber bolts. I just didn't want to get an alignment yet so I havent but them on yet. I may get some 205s in the front. I'll still drive it around for a little while and see. The front only rubbed on hard bumps, but the extra wide tire may be killing my MPG! I'll see how bad it is in a few more days.
#546
The front actually stopped rubbing on highspeed dips, but the rear is rubbing. I am not sure what it is rubbing, but I dont think it is the fender. You got any idea Mx6GT89? You said you just rolled your fenders and everything was good, right?
#547
#548
Nice Should fill up the wheel gap! And I get your HFP's!!! YES!
#550
Just got them installed. Crappy cell phone pic but couldn't resist.
Buddy club P1 17x7 +42 with BFG G-Force KDW's
So far a slight rub in the rear end but i do have all 4 of the stock rims back there. i'll let ya know when i take them out.
Buddy club P1 17x7 +42 with BFG G-Force KDW's
So far a slight rub in the rear end but i do have all 4 of the stock rims back there. i'll let ya know when i take them out.
#552
700 for the rims with shipping. 500 for the tires with shipping.
#553
Rimmys
I've got 16X7 Rota JMags with the polished look.
~Alex
~Alex
#554
#555
ive installed 16" rota jamgs on alot of fits. the only time that i've seen thse rub was when they were put on a 45 series tire. i usually recommend a 205/40/16 setup with these wheels. the cars were also lowered with tanabe df210 springs.
#556
Thanks
Chris
#557
The recommended tire size is a 205/45/16, I tried these on the HFP wheels, they work fine. However, when I did a 205/45/16 on the Rota Jmags, the wheels would rub in the rear with passengers loaded into the car. Therefore, on every Fit that I lower, I use a 205/40/16 tire to eliminate that rubbing issue. Not to mention, tires for the size 205/40/16 are more available/cheaper than the 205/45/16.
#558
Good idea. I think ill use 205/40/16 when I get the Fit to avoid rubbing.
#559
J-Mags
At last photo of Fit/Jazz on J-Mag. Thank you Alex. I orderd J-Mags on my imagination (couldnt find photo anywhere) and now I see, it was a good choice. If you have more photo to post, pls do.
N.B. "Hyper Rev" recomends: 185/55-15 ; 195/45-16 ; 205/40-17
N.B. "Hyper Rev" recomends: 185/55-15 ; 195/45-16 ; 205/40-17
#560
The recommended tire size is a 205/45/16, I tried these on the HFP wheels, they work fine. However, when I did a 205/45/16 on the Rota Jmags, the wheels would rub in the rear with passengers loaded into the car. Therefore, on every Fit that I lower, I use a 205/40/16 tire to eliminate that rubbing issue. Not to mention, tires for the size 205/40/16 are more available/cheaper than the 205/45/16.
205/45/16 on 16x7 Rota JMags, in your particular case rubbing with stock or lower suspension?
Thanks a lot.
Chris