CVT relearn ???
New Member
Joined: Nov 2022
Posts: 1
From: ALABEL (Capital)
1. Reset the ECU by removing the negative terminal of the battery for about 5 minutes then reconnect it. 2. Ensure that everything is off or there is no electrical load to the car like stereo, lights, dashcams and ensure to close the door as well. Turn on the ignition for about 2-5 seconds then start the engine. Hold the RPM steady to 3,000rpm for 5 minutes. 3. After 5 minutes, release the gas pedal and let it idle until both fans (radiator & condenser fans) complete two cycle run. You can step outside the car, pop the hood and watch the fans till they complete the two cycles. 4. After two cycles of running for both fans, leave the engine running and turn on the AC for another 5 minutes. 5. After 5 minutes for the AC running, turn it off. You can idle the car or turn it off and its already relearned.
Thread
Thread Starter
Forum
Replies
Last Post
Hondarian
1st Generation (GD 01-08)
0
Feb 13, 2017 07:32 PM
sanosuque
Fit Engine Modifications, Motor Swaps, ECU Tuning
6
Jan 26, 2008 03:23 PM