Just ordered my Honda Fit Body Side Molding from Zeta. Was thinking of using a chalk line or laser level to line them up and was wondering what you used to get the on decent?

 

blue masking tape!!!!

 

yeah, use masking tape and rulers.

 

What they both said. Thats what I did for my Jazz moldings.

 

Well blue masking tpe it is. Thanks for the input

 

Well it's on and as the thread dies off, I'd offer one small tech tip.

Thanks for the comments. I see the masking tape is called out and I guess I was thinking this would be another item with no directions when I started this. I mean non English direction like my window vents.

When pealing off the protection tape, on the back of the molding, and as the directions say, just start it, do not pull it all off.... I'd add start with the short pointy end 1st and get it off and into the long section before placing it in place. I did the opposite and on one section found the masking tape did not start or pull off the short section on the pointy end. I caught it and pulled it off with tweezers.

This is a great adder to any Fit because it's small and clean and will protect the Fit from idiots that slam the door open in tight lots.

 

Platypus Fit

 

i originally wanted those side moldings, but i saw them on some dudes fit from the phillipines and i didnt like how it looked. but they are VERY VERY functional. our cars have thinner sheet metal than first gen usdm subaru wrxs'

 

hey where did you get your jazz side moldings from? the only ones that i have been able to find are the zeta moldings and those are a little funny looking.

 

x2. i'd like side moldings as well, and OEM>*, so this interests me

 

excellent eye's

 

Haha, I even got up on the monitor to check it out!