hey guys just a quick question about front camber i have a gd3 and i just out on enkie 92 15x8 +25 offset. front are sticking out,and i know i need some camber bolts..but is there any other way to adjust front amber?..like to make it negative? I'm going to hav alignment tomorrow..so i just wanna know before they align everything...thanks

 

Camber plates, if available.
Lowering springs will reduce camber, but possibly create clearance issues with the fender.

 

thanks for your response..im on coil overs and I'm thinking if the 2 bolts from the lower strut can be adjusted to positive and negative camber?

 

you need to get two sets of camber bolts

 

ok maybe ill get them before alignment...how much negative degrees i could get with camber bolts?

 

do local auto parts store have camber bolts?..or just have to order it online?

 

You should get around 3 degrees. There is a thread somewhere around here with a Toyota part number for the bolts. Something like $25.

 

ok thai you sir..

 

Only one set of camber bolts is intended to be used on the front. Ask whether the shop will install/adjust two sets.

 

http://www.hrsprings.com/products/triple-c/

I have 2 sets of these for my race car. I'm at 2.6 degrees but the most is 3 degrees that I could get.

 

do you have pics?..i already order a set..and hopefully put them on tomorrow, my rear was rubbing so bad that i have to raise the back up a lil bit

 

Pics of the car or the bolts

 

pics of the camber

 

if i use just one set like the upper bolt..will that give me enough camber?...or not much difference?

 

One bolt in the upper hole should get you - 1.75 of camber.

 

also how easy to install the bolts?...torque specs?

 

If you want to get technical the book calls for 66lb ft of torque on the pinch bolts.

If you can jack the car up and take the wheel off you should be able to install the camber bolt.

 

thank you for the info. ill try it soon i get my bolts...