When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hit the mother load of Teg parts!
Plastics, lights, rear sway bar, bumpers, steering wheel, seats, full carpet, interior fuse panel, Cruz, a/c, wiring, sun roof! After I sort it out and start cleaning up the good stuff I'll post pix.
Last edited by Perrenoud Fit; Dec 10, 2017 at 06:51 PM.
Yes KC it was like WHAT your just giving all this away! Literally a whole truck load and the little stuff went in the back of my Teg. He had tried to sell it but no one hhu so last week it was "for free" my favorite words in a listing, lol.
I'm not sayin any of it's excellent shape, but it's refubishable !!
Last edited by Perrenoud Fit; Dec 14, 2017 at 09:01 AM.
Some of the parts are too weathered to use, like the air bag with water pouring out of it. But these are good and can be reused.
This had rusty water in the motor, pulled the back off, it was a mess inside. It started out just to see if I could get it running again. Cleaned the magnets and armature, used a wire wheel on a Dremel tool. Brake cleaned everything afterwards.
The most fun was getting the brushes back around the commutator . Used masking tape to hold them back in the guides, set the end back down and pulled the tape out with forceps. The rest went together easily and it ran!! It ran great. Cleaned up the blade and frame and now I have a good spare.
Last edited by Perrenoud Fit; Dec 16, 2017 at 04:16 AM.
Interesting my 94 has smooth mirrors without the bodylines that stand out, hummm? From what the mirror date code is there must be a design change probably '98.
Last edited by Perrenoud Fit; Dec 17, 2017 at 06:45 AM.
This poor little light had been left out in the weather and had major sun and water damage the panel was cracked so bad and sun bleached I tossed it. That killed me, lol. The housing was broken in three places. The lens was in need of some epoxy too. All in all it took 2 hours to bring it back to a 7 out 10. But it works flawlessly and for what it is and where it goes, it's great.
Last edited by Perrenoud Fit; Dec 18, 2017 at 08:58 PM.
Cargo light in a hatch trunk light in a sedan. They're kinda rare, and I wanted to see what it would turn out like. It turned out better than I thought it would! : ^ )
