do someone like to sell your usdm front and rear bumper to asia?

 

You will need a lot more than just the bumper up front to make the Swap work( the back one will work with minor mods ).....very labor intensive on parts that need to be un~welded and welded it back in... The GE Fit is just not as plug and play as the GD fit when it comes to the sway...... sorry to tell you this ( even if your doing JDM to USDM ).....

 

yup i kew it i need left and right front fender
headlamp, hood and maybe radiator and many more
i need to know......

 

I can give you a basic break down if you need..

Hood
Right fender
Left fender
Right headlight
Left headlight
Front bumper
( NEW Front subassy Radiator support and lower cross pan ) needs to be welded in....
Window wash bottle
Hood hinges L&R
Under fender support mount L&R ( need this part or you can't mount the fenders... it also has to be welded in )
Hood latch ( different from JDM one )
Hood support rod ( different from JDM one )
Radiator/ A/C support brakets
Headlight support brakets ( about 10~12 of these are needed )
Front window wiper cowling...( this is where you might run into a problem because the USDM hood sits about 1 inch(25mm) further forward than the JDM one... and if your car is a Right hand drive that means your wipers are on the other side.... not good news... that means you'll have to replace a bunch of stuff it you want to make it work!! )

I'm sure there is a few more things..... but.... you might want to think about it.....

 

okayyy
maybe in my country we can customized all of them
let me discuss with my workshop
thx for your info
maybe if you need some jdm stuff you can tell me
and if you dont mind add my yahoo messenger or msn messenger
we can discuss about our GE
thx

 

may i know the price for the front bumper is?

 

bumpppppppppp

still looking the usdm bumper