you saw felix which his fit is done up so much it hardly looks like a fit.

I drive around ballard every day.

where about in seattle are you?

 

I'm down south, which is probably why, lol. I'm just right next to Burien.

 

So, anyone going to the toy run this year?

 

yeah i would like to show there.

 

Should we setup a meet up spot so we can roll in together?

 

I might be down for this too.

If anyone is interested, I'm looking to sell my FF Type 2 Coilovers. Check the thread below.

https://www.fitfreak.net/forums/wash...overs-gd3.html

 

when is it?

Im down to roll down there and park together.

 

Info:
“NW TOY RUN 2011"
Date: December 4th 2011
Time: 12:00pm -to- 4:00pm
Place: Pacific Raceways
Address:
Pacific Raceways
31001 144th Avenue Southeast,
Kent, WA 98042-4601
(253) 639-5927
pacificraceways.com
unopened toy, or $5

 

I'll be down. We should plan a meet up before then! What does everyone's weekend look like? I work Mon-Fri so I have them off. Even if it's just a couple of us that want to get together and hang out in Seattle or something, I'm down. I'm in NE Renton area. Hit me up on facebook.

www.fb.com/theindiearmy

 

Just got the brakes done on the Fit finally. Had to buy a impact wrench for the rotors but it was worth the $50

The final destination for the Toy Run is Pacific Raceways so maybe we could meet up somewhere near hwy 18.... anyone got any ideas?

 

anyone knows how to install clutch onto the FIT? dom? done it before right?

 

So my buddy and I will be leaving my house on the 4th to caravan to the toyrun. Anyone wanna join in? Can either all leave my place at a set time or meet up some where and caravan into Pac Raceways.

 

Looks like the wa community has turned into a ghost town again.

 

Ya, I've done it a few times but not recently. I haven't had a car long enough to change one since college.

 

I actually will try and go! I haven't been to a meet in a LONG time.

 

well, according to what i've read about the assembly of the tranny/engine of the FIT, compared to the dc5's tranny, (the one you swapped with long time ago), it's lot less complicated, IMO. plus, we are talking about clutch replacement, , not engine swap, so i am sure it's lot easier than swappin' the k20a...if you are down, i'll start planning on funds to buy an OEM clutch plus a new flywheel, and hopefully my clutch can keep me through winter, when spring comes, we can work on it. how's that sound?

 

The swap your referring to was just after college, when I moved here. I've done way more than that. Im sorry Andy, I won't have time for that to be honest, perhaps someone else can assist?

 

Happy Turkey Day Wa Fit Freaks!

 

it's all good man, i forgot you are almost there in fatherhood, you'll got your hands full by spring time. understandable. i am not too concern about it NOW, just that among the ppl i've met/known, somehow you seemed to have an upper hand in knowledge of every vehicle you've owned, that's why i asked you for this task. it's all good buddy. we shall meet up sometime in the spring. happy thanksgiving to all.

 

Anyone doing the toy run december 4th?