Thread: Weapon R Secert Weapon Intake setup
View Single Post
  #13 (permalink)  
Old 11-04-2008, 03:09 AM
petwhookie's Avatar
petwhookie petwhookie is offline
Member
iTrader: (5)
  
Join Date: Feb 2008
Location: Bay Area, CA
Posts: 637
Rep Power: 34627
petwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to livepetwhookie relies on Rep Points to live
Picture time!!!

So the problem was the "ram kit" WR supplied me with did not fit the hole (by the intake/near the driver's headlight). The ram kit was too big and I could not fit it without some elbow grease.

Here in this picture is how the intake sat normally. I was stumped how that ram kit was going to fit through that hole.



With some elbow grease, I moved the intake and the filter around. Flattened the ram kit a little and it all fit.




Butt dyno = no gains felt
Intake temp did drop 8 degrees according to my scanguage
Last edited by petwhookie; 11-04-2008 at 03:12 AM.
Reply With Quote