I'm seriously thinking about getting an aftermarket seat for my car. I'm curious if the airbag plug for the seat is a 2 or 4 pin connector. I know the steering wheel airbag is a 4 pin so you need 2 resistors, at least that's what was supplied with my Works Bell hub and I have no SRS light with the Momo wheel.


Thanks!

 

I know for cars like the EP3 and DC5 you cannot completely fool the system with resistors. Any sensors or modules located in the seats need to be removed from the seat and remain in the equation, then you can use a resistor the mimic the load of the airbag. Sorry for not having a Fit specific answer, but I hope it gets you thinking.

 

I just had the seat out today, I should have looked at what it was. One thing that caught me by surprise is the base of the seat belt is connected to the seat rail. So to get new seats you have to figure out how to mount the seat belt.