Very nice writeup on the lighting mode switch!!

 

Anyone know where I can get the connection that would allow me to actually plug this into that port?


http://cimg9.ibsrv.net/gimg/www.fitf...d2a5e329c5.jpg


My wiring keeps shaking loose and falling off the pins.

 

I assume you've tightened up the crimps a few times? Mine went on very stiff and have stayed put for nearly 20k miles.

 

Instead of using the positive pin, I used a $5 fuse tap which is a very secure connection. I only have to worry about the black wire coming loose, but it hasn't come loose at all for the 6,000 miles I've had it wired. Use a flattened molex connector, that is slightly too flattened to fit over the pin, so that when you force it over the pin, it is squeezing the pin tight. Then I taped down the wire so that pulling on the wire would hopefully not pull on the molex connector.

I wrote instructions about using a fuse tap here:
https://www.fitfreak.net/forums/3rd-...de-always.html