Another quick question about pnp Hid
#1
Another quick question about pnp Hid
the hids finally started working after i turned the plug around... but it only works when my high beams are on... which kills the look of yellow fogs/hids... did i do sumtin wrong or how do i get it back to low beam only?
#3
yo, you have to switch around the plug. i had the same problem. There's that three plug harness thing right? if i remember, i put the ground on the top and the power on the left side to plug it in. if you have a volt meter it'll help you find the power for the low beams. hope that helps O_o
#4
yo, you have to switch around the plug. i had the same problem. There's that three plug harness thing right? if i remember, i put the ground on the top and the power on the left side to plug it in. if you have a volt meter it'll help you find the power for the low beams. hope that helps O_o
Thread
Thread Starter
Forum
Replies
Last Post
oneduduboy
Fit Interior & Exterior Illumination
2
06-14-2007 03:20 PM
potatoo
Fit Interior & Exterior Illumination
2
01-15-2007 12:39 AM