how do I get 200 hp
This thread hurts my brain.
Ya'll need some NOS!!11!
There are no Hasport mounts.. and these aren't the droids you're looking for.
Ya'll need some NOS!!11!
There are no Hasport mounts.. and these aren't the droids you're looking for.
Last edited by DiamondStarMonsters; Dec 19, 2010 at 09:58 PM.
$5,995.00 for a K20A:
K20A RSX TYPE R K20A
You also need to buy a hi po clutch, pressure plate, throw out bearing, header, and custom half shafts and pay a shop to create custom motor mounts. Fit harness will need to be modified by Hondata to fit the K20. It is going to be a real tight fit in the engine bay so you will need low profile radiator and condenser fans to attach to the radiator with custom fan mounts. You will need to buy a snail intake manifold because there is very little room.
How much $ are you going to drop on an econobox?
K20A RSX TYPE R K20A
You also need to buy a hi po clutch, pressure plate, throw out bearing, header, and custom half shafts and pay a shop to create custom motor mounts. Fit harness will need to be modified by Hondata to fit the K20. It is going to be a real tight fit in the engine bay so you will need low profile radiator and condenser fans to attach to the radiator with custom fan mounts. You will need to buy a snail intake manifold because there is very little room.
How much $ are you going to drop on an econobox?
Last edited by xm8; Dec 25, 2010 at 02:35 AM.
$5,995.00 for a K20A:
K20A RSX TYPE R K20A
You also need to buy a hi po clutch, pressure plate, throw out bearing, header, and custom half shafts and pay a shop to create custom motor mounts. Fit harness will need to be modified by Hondata to fit the K20. It is going to be a real tight fit in the engine bay so you will need low profile radiator and condenser fans to attach to the radiator with custom fan mounts. You will need to buy a snail intake manifold because there is very little room.
How much $ are you going to drop on an econobox?
K20A RSX TYPE R K20A
You also need to buy a hi po clutch, pressure plate, throw out bearing, header, and custom half shafts and pay a shop to create custom motor mounts. Fit harness will need to be modified by Hondata to fit the K20. It is going to be a real tight fit in the engine bay so you will need low profile radiator and condenser fans to attach to the radiator with custom fan mounts. You will need to buy a snail intake manifold because there is very little room.
How much $ are you going to drop on an econobox?
Last edited by kelsodeez; Dec 25, 2010 at 03:08 AM.
i am done talking to you because it is impossible to hold a conversation with a retard.

sorry, i dont help idiots that dont know how to research for themselves.
Idk thats a pretty good deal, but you sound legit!
I hear no one makes mounts though. Shame that

NOS it is then!





psh. ya'll are simple. rear mounted ls7 all day up in this mother. I used the stock engine mounts but the blinker fluid had to be swapped out for synthetic because there were too many horsepowers and the light was flashing too slow.
Jesus, this thread made my brain hurt. If people don't know where to get a k20 or swap parts then maybe they should leave a shop to do the work for them.
Jesus, this thread made my brain hurt. If people don't know where to get a k20 or swap parts then maybe they should leave a shop to do the work for them.



