For the ge jazz you just need an air intake which has a point for the MAF sensor to fit in and it's all good yeah?

 

the new connector HAS to have the correct size inside to match the stock one or you will get MILs.

 

I dot get what you mean, so inside where the MAF sensor sits its built for certain MAF sensors so if its not the correct one it won't work?

 

the TUBE size must match oem.

The sensor calculates airflow based on that specific tube section area.

With it smaller, it will run very rich, even if the difference is small.

With it larger, it will run very lean and cost you a motor at worst case

 

So if I was to find a intake that has the right fit it is usable? Thanks for the replies

 

Yea the part right where the MAF sensor is put into. The inside diameter right there has to be the same size as stock. There is one that everybody has good luck with on GEs if you can find one down there. The PRM intake. There are some threads on it.