Running high and low beams
#1
Running high and low beams
I've read about running the independent fog lights. but I really would liek to run all of my lights when I click the high beams.
Has anyone done this? Any help would be appreciated.
Thanks
Cola
Has anyone done this? Any help would be appreciated.
Thanks
Cola
#2
Are you talking about running high & low beams at the same time?
I think a bulb that I recently purchased cautioned against that - maybe because having both filaments on at the same time would create too much heat and pop the bulb.
When my bulbs burned out at about 100,000 miles, the filament made quite a bubble in the glass of both - bursting one of them.
I think a bulb that I recently purchased cautioned against that - maybe because having both filaments on at the same time would create too much heat and pop the bulb.
When my bulbs burned out at about 100,000 miles, the filament made quite a bubble in the glass of both - bursting one of them.
Thread
Thread Starter
Forum
Replies
Last Post
zaobfit
Fit DIY: Repair & Maintenance
3
11-22-2014 09:02 AM
xxryu139xx
Fit Interior & Exterior Illumination
5
11-23-2013 04:07 AM
jaythomas
Fit Interior & Exterior Illumination
16
02-13-2009 01:06 AM