Help!!!! I need help installing subs
#1
Help!!!! I need help installing subs
Hey guys I just purchased my 2010 Honda fit sport I recently had 2 12' jl audio subs in my grand am today I cut the box in half and re carpeted it I just want to insatll one sub I have the amp wires and equipment and the general knowledge to install em into an aftermarket head unit but I'm keeping my HU stock so how would I go about installing them to a door and where is a good place to find a ground also I have a 1000 watt amp is the battery to small to even power that. Is it possible for any one to post a walk through for the install. P.s. The car rocks!!
#2
i could be wrong but i don't think you would be able to install the amp and sub without getting the aftermarket head unit. Any metal part on the car can serve as a ground. If its painted, just sand it down to the middle to make the connection better. As for power, you could always go with a separate battery to power the sub, or even both. A capacitor could also be used for power issues.
#5
I'm doing that too, the signal from the HU to the amp needs to get "just" the signal and not the amplification from the HU.
To do this a LOC80 is wired between the rear set of spkrs and the amp. shaun954 told me about this and this W.E.
I'll be wiring all this together.
Where can you get a 4ga power through the firewall to the battery?
To do this a LOC80 is wired between the rear set of spkrs and the amp. shaun954 told me about this and this W.E.
I'll be wiring all this together.
Where can you get a 4ga power through the firewall to the battery?
Last edited by Perrenoud Fit; 09-30-2010 at 09:24 PM.
#6
just hook it up normal and use a high to low converter. they are like $20 run the amp just like you would be useing a aftermarket headunit. splice the high to low converter to the rear speakers and run a small set of rca wires to it it really that simple!
the only hard part is finding out what color wire it is caue i know the gd3 it blu/pnk,pnnk and if i remember correctly the other side was green? thats how mine is set up!
the only hard part is finding out what color wire it is caue i know the gd3 it blu/pnk,pnnk and if i remember correctly the other side was green? thats how mine is set up!
#7
GD3 Stereo Spkr. Color Code
Perrenoud Fit
GD3 Stereo Spkr. Color Code
L frnt = + green/black, - light green
L tweeter same wires
R frnt = + green/yellow, - gray/red
R tweeter same wires
RR = + blue/white, - blue/black
LR = + pink, - blue/yellow
Perrenoud Fit
GD3 Stereo Spkr. Color Code
L frnt = + green/black, - light green
L tweeter same wires
R frnt = + green/yellow, - gray/red
R tweeter same wires
RR = + blue/white, - blue/black
LR = + pink, - blue/yellow
Thread
Thread Starter
Forum
Replies
Last Post
GE8_typeR
2nd Gen GE8 Specific Fit Interior Modifications Sub-Forum
7
10-26-2012 12:26 AM