Hot to install a Cusco Front tower bar in a GE8
#1
Hot to install a Cusco Front tower bar in a GE8
How* not Hot
Ok I have another thread for the rear strut bar but in wanted a fresh one for the front so here it goes
I started off removeing the cowl panal plastic
Then i set the bar up in there and found which bolts to remove to install it.
and then tighten then up and barly cleared the brake resivor i had about 1mm of space cleared
but then i popped the cowl back on and it was done
here are some bonus pics
Ok I have another thread for the rear strut bar but in wanted a fresh one for the front so here it goes
I started off removeing the cowl panal plastic
Then i set the bar up in there and found which bolts to remove to install it.
and then tighten then up and barly cleared the brake resivor i had about 1mm of space cleared
but then i popped the cowl back on and it was done
here are some bonus pics
#2
looks good
nice right up also.
hows it drive now with both
front and back done?
man that is close on the brake res
thats going to suck when you have to add
fluid or change it. but then again how often
does that happen
nice right up also.
hows it drive now with both
front and back done?
man that is close on the brake res
thats going to suck when you have to add
fluid or change it. but then again how often
does that happen
#4
I'm not sure why it is there but it had hardware and was in the instuctions
#13
Awww looks great! I think I'll get one this weekend and post it here to.
Thanks AshPanda. Too bad no pics of where all the clips to be removed are located but I remember passing by a PDF somewhere on the net showing how to remove it.
Thanks AshPanda. Too bad no pics of where all the clips to be removed are located but I remember passing by a PDF somewhere on the net showing how to remove it.
#18
one bolt per side and one in the center... and as for accessing the brake res on a USDM car they make a bracket that lowers the res down about 10mm for the USDM version other than that the bars are the same