What did you do to your GE fit today?
Just be careful to clean both surfaces with isopropyl alcohol and apply even pressure, plus allow cure time. If you do that itll be almost impossible to tear off.
Nice haha yea I got these for a whoppin $160 imagine that probably a once in a lifetime find and I happened to be looking at the right time haha.
While inspecting the rear Swifts after a week of driving, I took some measurements of the rear trailing arm spring seats and wheel height while at rest and at full droop. It turns out the rear suspension Motion Ratio for GE8 is 0.9, and not the previously discussed 0.77. The rear springs' compression at rest also confirms the finding.
Last edited by eternal_fantasy; 08-18-2015 at 09:49 AM.
I just ordered 12tons hydraulic press, plus extra jack stand
and rear bolt for the disk brake conversion (Wilwood) from Summit Racing,
also
ordered, JDM Integra DC5 type R rear (Red) brake caliper and some other parts from Japan needed for the Front Brembo conversion...
Hope to order the Brembo Gran Turismo kit sometimes next week...
Ok, to make a slow thread just a bit faster
I just ordered 12tons hydraulic press, plus extra jack stand
and rear bolt for the disk brake conversion (Wilwood) from Summit Racing,
also
ordered, JDM Integra DC5 type R rear (Red) brake caliper and some other parts from Japan needed for the Front Brembo conversion...
Hope to order the Brembo Gran Turismo kit sometimes next week...
I just ordered 12tons hydraulic press, plus extra jack stand
and rear bolt for the disk brake conversion (Wilwood) from Summit Racing,
also
ordered, JDM Integra DC5 type R rear (Red) brake caliper and some other parts from Japan needed for the Front Brembo conversion...
Hope to order the Brembo Gran Turismo kit sometimes next week...
Good luck at the DMV, just be sure to go as early as possible
That would look good on my car in Taffetta White with the CF weave showing through
That would look good on my car in Taffetta White with the CF weave showing through
Finally installed this! Was going to install it directly into the lip but i just couldnt find the exact center as it was too difficult for me to measure, and commit to cutting a hole. Too many curves and angles to line up my tape measure to lol.
Last edited by connor55; 08-22-2015 at 10:05 PM.