Just be careful to clean both surfaces with isopropyl alcohol and apply even pressure, plus allow cure time. If you do that itll be almost impossible to tear off.

 

Yes you can, works great for keeping the wires in place and helping prevent corrosion from moisture.

 

thanks! 10 char

 

Nice haha yea I got these for a whoppin $160 imagine that probably a once in a lifetime find and I happened to be looking at the right time haha.

 

Finally after a long ass time these 3d decals came and I was able to finish off the engine cover.

 

That is BEAUTIFUL !

 

thanks man. different kind of proud when u made it urself. =)

 

Nice work ryu!

 

thnks connor!

 

The one i am talking about putting on is this one.

 

While inspecting the rear Swifts after a week of driving, I took some measurements of the rear trailing arm spring seats and wheel height while at rest and at full droop. It turns out the rear suspension Motion Ratio for GE8 is 0.9, and not the previously discussed 0.77. The rear springs' compression at rest also confirms the finding.

 

Installed the Canadian hood deflector that I found at a garage sale in Seattle for $20 a few weeks ago.

 

^ Nice, and it even has "Fit" if you purchase a new one they are made from a company called truefit, so it says that instead.

 

You know threads are slow when the thread that started because threads were slow, is slow.

 

Ok, to make a slow thread just a bit faster

I just ordered 12tons hydraulic press, plus extra jack stand
and rear bolt for the disk brake conversion (Wilwood) from Summit Racing,
also
ordered, JDM Integra DC5 type R rear (Red) brake caliper and some other parts from Japan needed for the Front Brembo conversion...
Hope to order the Brembo Gran Turismo kit sometimes next week...

 

Thank you. Can't afford upgrades now so I have to live vicariously.

 

Got my notice from the DMV that my personalized plates are in

But the soonest available appointment is Sept. 9th....forget that noise, im just going to be late to work monday

 

Good luck at the DMV, just be sure to go as early as possible

That would look good on my car in Taffetta White with the CF weave showing through

 

Finally installed this! Was going to install it directly into the lip but i just couldnt find the exact center as it was too difficult for me to measure, and commit to cutting a hole. Too many curves and angles to line up my tape measure to lol.

 

Looks good.. i've been thinking of doing this with the stock bumper..

How did you wire it and does it flash or is it a solid light when braking? Where did you get the led from?