Resetting ABS LIGHT
#2
There is probably a good reason why its on, resetting it doesn't fix the problem. You can clear the code by leaving the battery disconnected for 15-20 mins and it should clear any codes, if there is a problem the light will come back on though.
#3
If there is no problem the light should go off right away. If the red "break" light also is lit up, that means your break balancing is also not working (it is tied to the ABS pump in these) and you should be careful driving and look into having it serviced pronto.
#5
its a yellow ABS light that occurred when I went to a local shop to replace my wheel bearings. Afterwards I personally replaced the wheel sensors hoping the light would go away. No dice....
I was hoping to reset it to see if it lights up again. My understanding is that one the code lights up, it is saved and cannot be reset by disconnecting the battery.
I was hoping to reset it to see if it lights up again. My understanding is that one the code lights up, it is saved and cannot be reset by disconnecting the battery.
Thread
Thread Starter
Forum
Replies
Last Post
Vash
2nd Generation GE8 Specific DIY: Repair & Maintenance Sub-Forum
7
07-18-2018 03:19 PM