Door power lock not working. Actuator?
Thread Starter
|
New Member
Joined: Apr 2011
Posts: 8
From: Phoenix, AZ
Door power lock not working. Actuator?
I have a 2011 with 50K miles.
My right rear passenger door will not lock or unlock using the key or the lock switch on the driver side door. The actuator makes no noise.
At ~$120 for the part (72610-TF0-J01) I want to make sure it's the actuator. Is there any sort of diagnostic I can do? Can I apply +12V and ground to the actuator (momentarily) and see if it locks? The only issue is I do not know what pins are what on the actuator. The wires on the plug are green, black, yellow, sky blue'ish.
Thank you
My right rear passenger door will not lock or unlock using the key or the lock switch on the driver side door. The actuator makes no noise.
At ~$120 for the part (72610-TF0-J01) I want to make sure it's the actuator. Is there any sort of diagnostic I can do? Can I apply +12V and ground to the actuator (momentarily) and see if it locks? The only issue is I do not know what pins are what on the actuator. The wires on the plug are green, black, yellow, sky blue'ish.
Thank you
Member
Joined: Nov 2009
Posts: 134
From: Lexington, MA
Alternative
I would suggest testing the solenoid with an ohm meter. If open (infinite resistance) then replace. If there is resistance, then maybe the solenoid is stuck and you could free it up and grease it instead of replacing it.
Thread
Thread Starter
Forum
Replies
Last Post
gkitf16
2nd Generation GE8 Specific DIY: Repair & Maintenance Sub-Forum
17
May 4, 2026 07:57 PM
09Fitter
2nd Generation GE8 Specific DIY: Repair & Maintenance Sub-Forum
0
Jan 14, 2015 02:12 PM