The 2 button lights above you, how does that whole housing come out? I don't see any screws, does it pop out?

 

Are you trying to replace the bulbs to LEDs? You just use a pry tool to take off the clear pieces.

If you are trying to remove the whole assembly, it is most likely just in there with side clips so a pry tool should pop it out.

 

I pried some with a pry tool but didn't want to put too much pressure on it until I knew for sure what's holding it in there. But it didn't budge, the liner is giving.

 

hmmm... there maybe some sort of assembly diagram in the parts catalog. Check out an online parts catalog from any honda shop and usually there is a engineering type diagram of all the pieces. That might give a clue.

 

Pry the lenses out. There are two screws inside to remove the entire unit.

 

By lenses, you mean the plastic buttons and those just pry out?

 

Yes. Use a credit card to pry them.